A small entry about the settings I use to print the Xbox Adaptive Topper.
To get the STL file is very easy, from the Xbox Design lab page https://xboxdesignlab.xbox.com/ you just need to look for the shop and then click on Xbox Adaptive Topper options under adaptive Products.
You can design one for Standard controllers, Elite controllers or the brand new Adaptive Joystick. I got one for my Elite Series 2 Controller.
My first print, I decided to do it without supports and with just some Build plate adhesion (Brim – 5.0mm width – 10 line count) this was a mistake, the base did not have enough support or grip to maintain the topper.
So I realize supports were needed. I used the following setting in Cura
So everything came great with this one.
